Vincent

A high dynamic and a low noise level stand out for this amplifier. The music signal is conditioned through two 6N1 tubes.

Frequency response: 20 Hz - 20 kHz ±0,5 dB,Two 6N1 tubes deliver a classic warm sound
Nominal Output Power at 8 Ω: 2 x 25 W (RMS),Nominal Output Power at 4 Ω: 2 x 35 W (RMS)
Playable Digital Formats: WAV, FLAC, APE, LPCM, MP3, ACC, AC3, WMA
Inputs: 2 x Cinch stereo, 1x Coaxial IN, 1x Optical IN

The consequent enhancement of our succesful tube phono preamplifier, the PHO-700, has now the possibility to make exact adjustments for the pick-up cartridge through DIP-switches.

Frequency Response: 10 Hz – 20 kHz,T.H.D.: <0.05% (20 Hz - 20 kHz)
Input impedance: MM: 47 kOhm, MC: 99 - 1000 Ohm (adjustable)
Inputs: 1 x Stereo RCA,Outputs: 1 x Stereo RCA, USB

Now there are two more 6N16 tubes inside, located directly in front of the output
Because of this, the sound becomes more naturalness and more musicality.

Inputs: 5 x Stereo RCA, 1 x Stereo XLR
Outputs: 2 x Stereo RCA Pre Out, 1 x Stereo XLR Pre Out, 1 x Stereo RCA Rec Out
Frequency Response: 20 Hz – 20 kHz ,Tubes: 4 x 6N16

The SV-237 MKII appears more modern and elegant than its predecessors. Modern now also with the connection possibilities.

Frequency Response: 20 Hz - 20 kHz,Tubes: 1 x 12AX7; 2 x 6N1P
Nominal Output Power RMS / 8 Ohm: 2 x 150 Watt
Nominal Output Power RMS / 4 Ohm: 2 x 250 Watt
Inputs: 3 x Stereo RCA, 1 x Optical, 1 x Coaxial, 1 x Bluetooth.

The Vincent PF-2 powerfilter eliminates all disturbing influences (e.g. buzzing) in your Hifi or Home Cinema system, which is caused by the electricity network. 

Max. switching capacity: 2200 Watt
Input: 220 - 240 V/50 Hz AC (max. 10A / 2200 W)
Outputs: 2 x Schuko sockets for digital (300 W), 
4 x Schuko sockets for analogue (1900 W)

Phono-Preamplifier for connecting your turntable to a line input of your amplifier. The low-noise phono-preamp is suitable for MM and MC cartridges.

Frequency Response: 10 Hz – 20 kHz
Input Sensitivity MM: 58 mV, MC: 6,8 mV
Inputs: 1 x Stereo RCA,Outputs: 1 x Stereo RCA

Very complex is also the external power supply which minimizes all influences from outside.

Frequency Response: 10 Hz - 20 kHz
Input Sensitivity: MM: 58 mV, MC: 6,8 mV
Inputs: 1 x Stereo RCA,Outputs: 1 x Stereo RCA

A unsophisticated and low noise playback is the "job" of a good phono preamplifier.With the PHO-500 we managed this. T

you can make individual adjustments by DIP-switches on the PHO-500.
Frequency Response: 10 Hz – 20 kHz
Signal-to-Noise: MM: > 83 dB, MC: > 70 dB
Input Impedance: MM: 47 KOhm, MC: 100 Ohm - 1000 Ohm (adjustbale)

The music signals which are converted by the excellent Burr-Brown chip PCM176, are being prepared by one 6N2 tube. For reading CDs we use the proven Sanyo DA11 laser unit in combination with a Philips servo board.

D/A Converter: 24 bit / 192 kHz,Signal-Noise Ratio: > 93 dB
Frequency Response: 20 Hz – 20 kHz,Tubes: 1 x 6N2
Outputs: 1 x Stereo RCA, 1 x Optical, 1 x Coaxial

The DAC-1MK converts digital music files with a max. sampling rate of 32 bit / 384 kHz (DSD). The core is the ES9038 decoder, which processeds the signal fully balanced to the analog section.

Sampling Rate Coaxial, Optical: PCM 24 Bit / 192 kHz (DSD 64)
Sampling Rate USB: PCM 32 Bit / 384 kHz (DSD 256)
Inputs: 1 x USB, 1 x Optisch, 1 x Coax,
Outputs: 1 x Stereo RCA, 1 x Stereo XLR

To get the best sound quality of your headphones, an external headphone amplifier is needed. 
In It was designed that almost every headphone could be driven with the best sound quality.

Frequency Response: 20 Hz - 20 kHz ,Signal-Noise Ratio: > 95 dB
Tubes: 2 x E180F/6SCH9P, 1 x ECC82

With a little less output power, but with a similar timeless design and with the typical Vincent sound characteristics the SV-500 is presented.

Frequency Response: 20 Hz – 20 kHz,
Inputs: 4 x Stereo RCA, 1 x Optical, 1 x Coax
Nominal Output Power RMS/8 Ohm: 2 x 50 Watt
Nominal Output Power RMS/4 Ohm: 2 x 80 Watt

The SV-228 is the consistent further development of one of ours successful amplifiers series in the Power Line. In a complete new design, with a VU meter embedded in the front panel.

Nominal Output Power RMS / 8 Ohm: 2 x 100 Watt
Nominal Output Power RMS / 4 Ohm: 2 x 180 Watt
Tubes: 1 x 6N4, 2 x ECC82
Inputs: 2 x Stereo RCA, 1 x Coaxial, 1 x Optical, 1 x Bluetooth

A completely new combination amplifier was developed for the SP-T700, exploiting the respective advantages of tubes and transistors in an innovative manner, combining them to create a harmonious whole.

Frequency Response: 20 Hz – 20 kHz,Inputs: 1 x Mono RCA
Nominal Output Power RMS / 8 Ohm: 150 Watt
Nominal Output Power RMS / 4 Ohm: 300 Watt
Tubes: 1 x 6S3P-EV; 1 x 6SCH9P, 1 x 6Z4

Two additional 6N16 tubes were added to the input section to make the sound signal more warm dn natural. The VU-meters with user selectable colored backlighting complete the timeless design.

Frequency Response: 20 Hz - 20 kHz,Tubes: 2 x 6N16, 1 x 6N15
Nominal Output Power RMS / 8 Ohm: 2 x 150 Watt
Nominal Output Power RMS / 4 Ohm: 2 x 250 Watt
Inputs: 1 x Stereo RCA, 1 x Stereo XLR

The abbreviation DAC already indicates that it is possible to transfer external digital signals (optical, coaxial or USB) to the excellent Burr-Brown D/A converter PCM 1796, thus profiting from the fantastic analogue signal processing.

D/A converter: 24 bit / 192 kHz,Frequency response: 20 Hz - 20 KHz
Inputs: 1 x USB, 1 x digital optical, 1 x digital coaxial
Outputs: 1 x stereo RCA, 1 x stereo XLR,1 x digital coaxial
Tubes: 2 x 6922, 1 x 6Z4, 1 x 12AX7B

After several successful years, we have revised our reference preamplifier.

Frequency Response: 10Hz – 100kHz
Inputs: 6 x Stereo RCA, 1 x Optical, 1 x Coaxial, 1 x Bluetooth
Tubes: 4 x 6SCH9P, 4 x 6SCH51P, 1 x 85A2

Our new flagship of the integrated amplifiers. The preamp section was completely new developed and benefits a lot of the SA-T7. Through the build-in Wifi modul the amplifier music streaming could be done and it could be integrated in your home network.

Frequency Response: 20 Hz - 20 kHz
Nominal Output Power RMS / 8 Ohm: 2 x 180 Watt
Nominal Output Power RMS / 4 Ohm: 2 x 300 Watt
Tubes: 2 x 6N1P, 2 x 6N2P, 1 x 85A2

We decided on a consistent symmetrical design to minimize crossfeed and achieve a better distortion factor. In the pre-amp, 3 tubes per side work with the Shunt Regulatet Push-Pull concept to process the souond signals.

Frequency response: 20 Hz – 20 kHz,Input sensitivity: 350 mV
Nominal output power RMS / 8 Ohm: 2 x 100 Watt, RMS / 4 Ohm: 2 x 160 Watt
Inputs: 3 x stereo RCA, 1 x stereo XLR, 1 x optical, 1 x coaxial
Tubes: 1 x 6Z4, 2 x 12AX7, 4 x 12AU7

With the SA-T7 Diamond we have created a very special edition of our reference preamplifier, the SA-T7 MK. The heart of the preamplifier was equipped with original Telefunken tubes from German production.

Frequency Response: 10Hz – 100kHz +/- 0,1 dB
Inputs: 6 x Stereo RCA, 1 x Optical, 1 x Coaxial, 1 x Bluetooth
Tubes: 4 x Telefunken PCF 803, 1 x 85A2